Eliminating flickering or blurring, 2 press the menu button, A 1328 – Sony CPD-L150 User Manual
Page 11: 5 press the menu button, Customizing your monitor
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Eliminating Flickering or Blurring
If a part of the screen is flickering or blurring, press the
AUTO button. If this operation does not work, adjust the
Pitch and Phase as follows.
^
Once the pitch and phase are adjusted, they will be stored in
memory for the current input signed.
1
Load the Utility Disk (page 10).
2
Press the MENU button.
The MENU OSD appears.
MENU
MENU OK-igi
mPHASE
on) PITCH
CSCENTER
SSZOOM
B COLOR
B LANGUAGE
aOPTION
3
Press the buttons to select PITCH, and press the
MENU button again.
The PITCH OSD appears.
MENU
PITCH
(HD
a
1328 □
4
Press the +/- buttons until the screen color becomes
uniform.
If you are using the Utility Disk, adjust so that the
vertical stripes disappear.
a
5
Press the MENU button.
The MENU OSD appears.
If horizontal stripes are observed over the entire screen,
adjust the Phase in the next step.
Customizing Your Monitor
6
Press the buttons to selea PHASE, and press the
MENU button again.
The PHASE OSD appears.
«(3
MENU
3
PHASE
26
7
Press the +/- buttons until the screen color becomes
uniform.
If you are using the Utility Disk, adjust imtil the
horizontal stripes are at a minimum.
3
3b
The OSD automatically disappears after about 30 seconds.
To close the OSD, press the MENU button again.
To turn off the test pattern, click I END I on the screen.
11