Sony CCD-F301 - Manual (Page 22)

If you do not record Ihe age while recording
You cannot add it later during playing back or editing.
Be Sure to lollow the procedure ' Recording the Age"
while recording
About memory back-up
The camcorder uses the lithium battery on Ihe bottom to
keep the birth dale event dale in memory On Mhium
battery life, see page
18
When you connect Ihe camcorder to a TV
If you da not use Ihe data screen function, the age
indication will appear on the TV screen when the [
1]. [i],
or 1 31 indication goes out in the viewtmder and recording
42
Connections for Playback
You can easily make a proper connection ol Ihe
camcorder and TV by using the supplied AC V60'
V60A AC power adaptor
Check Ihe type of your TV, and go to the
appropriate section.
You can also connect the camcorder directly to
the TV, using the VIDEO AUDIO (and RFU DC
OUT) jacks. In this case, set the IN/OUT selector
to OUT.
Connecting a TV without Video
Audio Jacks (0-i)
Connecting iho AC power edaptor end a TV
The supplied RFU-90UC RFU adaptor and AC
power adaptor are required.
Make sure that the TV is turned off to prevent the
speaker being damaged.
1 Connect the antenna and TV to Ihe RFU
adaptor.
2 Connect Ihe RFU adaptor to the AC power
adaptor.
3 Connect the AC power adaptor to a wall
outlet.
4 If you have connected your TV using only
the antenna socket, set the channel
selector on Ihe RFU adaptor to 3CH or
4CH of Ihe VHF channel, whichever Is not
active In your area.
One ot the TV channels will be adjusted to
receive the camcorder s playback signal
Usually keep the AC power adaptor and the TV
connected
Whenever pleying beck a tape
Proceed only the following two steps
5 Attach the connecting plate of the AC
power adaptor to the camcorder.
6 Set the CHARGE/VTR selector on Ihe AC
power adaptor to VTR (DC OUT).
When you watch a TV program
Set Ihe CHABGEA/TR selector on the AC power
adaptor to OFF or turn oM the power o( the camcorder.
43