Sony SA-VA1 - Manual (Page 13)

2
Press TEST TONE.
A test tone is output automatically from each speaker
in the following order
Front (L) ♦ Center (C)
♦ ♦
Rear ♦ Front (R)
TEST TONE
im
Remote commander
Adjust the sound level of the center and rear speakers
and the balance of the sound from the front speakers
with CENTER LEVEL +/- REAR LEVEL +/- and
BALANCE L/R to obtain the same sound level from
each speaker in respect to your listening position.
The volume of the center and rear speakers appears
on the display, and is adjusted in a range of -t-lO dB to
-10 dB, in 1 dB steps.
CENTER
LEVEL
Œ]
REAR
LEVEL
- BALANCE -
Remote commander
4 Press TEST TONE to turn off the test tone signal.
TESTTONE
CD
m BALANCE L/R buttons
Use the BALANCE L/R buttons to obtain symmetry in
the sound image.
Press BALANCE L to move the sound image leftward.
Press BALANCE R to move the sound image rightward.
■- BALANCE ->
QD CD
Remote commander
Note
Since the BALANCE L/R buttons control sound from the
front right and left speakers, they have little effect in the
DOLBY PRO LOGIC modes (see page 14) for sources
with a high proportion of center-channel components.
I
DELAY TIME button
The DELAY TIME button allows you to change the
spatial characteristics of the sound in DOLBY or DOLBY
PRO LOGIC modes.
Press DELAY TIME to choose one of the following delay
times:15,20,25, and 30 ms. The selected delay time
appears on the display.
DELAY TIME
CD
Remote commander
[H] STD LEVEL button
Press STD LEVEL to restore the volume level of the
center, rear, super woofer speakers and delay time to
their factory settings (the STD LEVEL indicator lights
up), and again to restore the previous volume level of
each speaker and delay time.
If the super woofers are off, pressing the STD LEVEL
button causes the super woofer speakers to turn on
automatically.
STD LEVEL
(CD
Operation panel Remote commander
13