Sony RM-V7 - Manual (Page 3)

5
Press and release the ENT (Enter) button to store
the code number in the Commander's memory.
6 Go to "Step 2: Checking if the Code Number
Works" to finish setting up.
If you press a wrong button in step 4
Press and release the
S (Set) button and then go
back to step 2.
Step 2: Checking if the Code
Number Works
1
2
Power on the component you want to set up
using the component's power switch.
Aim the Remote Commander at the component
and press the
POWER button. f---------------- n
^ ( power )
The component should power off.
When the component powers off, check that the
Commander is operating the other functions of
your component, such as channel and volume
control.
CH
©
0 0
If the Commander Doesn't
Seem to Be Working...
• First, try repeating these setup procedures using
the other codes listed for your component.
• If - after trying all the codes listed for your
component - you still cannot get the Commander
to work properly, try the search method described
under "Searching for the Correct Code".
• If you still cannot get the Commander to work
properly, see "Troubleshooting".
If the Commander Seems to
Be Working Properly...
• You're finished setting up the Commander for this
component.
• If you're setting up more than one component (or
a TV/VCR combination), you'll need to complete
these procedures for each component vou plan to
use with the Commander.
• Use the label (supplied) to write down the code
numbers of your components. Then affix the label
to the back of the Commander.
Using the Remote
Commander
Turning On/Off a Component
1
Press the button of the component on the
Commander that you want to turn on/off.
(VCR CABLE TV )
( ) CD CD
2
Point the Commander directly at the
component.
3
Press the POWER button to power on/off the
component.
( power )
Note: There may be cases you may turn on/off the
cable box by pressing the
CH + or CH - button on
the Commander.
Operating a Component
1 Press the button of the component on the
Commander that you want to operate.
2
Point the Commander directly at the
component.
3
Press the button for the function you want to
use.
See "Remote Button Descriptions" for complete
descriptions of the buttons on the Commander.