Sony RM-V7 - Manual

3-856-604-11 (1)
Remote Commander
Operating Instructions
Manual de instrucciones (parte posterior)
RM-V7
Sony Corporation © 1996 Printed in Malaysia
English
WARNING
This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection
against harmful interference in a residential
installation. This equipment generates, uses, and
can radiate radio frequency energy and, if not
installed and used in accordance with the
instructions, may cause harmful interference to
radio communications. However, there is no
guarantee that interference will not occur in a
particular installation. If this equipment does
cause harmful interference to radio or television
reception, which can be determined by turning the
equipment off and on, the user is encouraged to try
to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment
and receiver.
•Connect the equipment into an outlet on a circuit
different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV
technician for help.
You are cautioned that any changes or
modifications not expressly approved in this
manual could void your authority to operate this
equipment.
About This Remote
Notes on Batteries
• Under normal conditions, batteries will last up to
six months. If the Remote Commander does not
operate properly, the batteries might be worn out.
When replacing batteries, replace both of them
with new ones.
• Do not mix old batteries with new ones or mix
different types of batteries together.
• Whenever you remove the batteries - to replace
them, for example - the code numbers you've set
are automatically erased and must be reset.
• If the electrolyte inside the battery should leak,
wipe the contaminated area of the battery
compartment with a cloth and replace the old
batteries with new ones. To prevent the
electrolyte from leaking, remove the batteries
when you plan to not use the Commander for a
long period of time.
Setting Up the
Commander
Press TV, f vCR CABLE TV )
VCR or (^—) (—^ (“—)
CABLE
Enter code (g) (g
♦