To listen to the current recording, To review the current recording instantly, To select the microphone sensitivity – Sony ICD-R100VTP User Manual
Page 13: To monitor the recording, Maximum recording time, Recording messages (continued)
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Recording Messages (continued)
Note on recording
Noiso ma\’ be recorded it
c\n
object, such as vour finger, etc., accidentally rubs
i>r scratches the unit during recording.
To listen to the current recording
Press •REC/STOi’ or ■STOPto stop recording, then press ►PLAY/
STOP.
To review the current recording instantly
Press ►PLAY/STOP during recording.
To select the microphone sensitivity
You can select the microphone sensitivity by switching the MIC SENS
selector on the rear of the unit.
H (high): To record at meeting or in a quiet and/or spacious place.
L (low): To record for dictation or in a noisy place.
Recording with an external microphone or from other
equipment
See page 22.
To monitor the recording
Connect an earphone or headphones (not supplied) to the EAR jack. You
can adjust the volume with the VOL control, but the recording level is
fixed.
Note
If you turn up the volume excessively or place the earphone near the
microphone while monitoring recording, the microphone may pick up the
sound from the earphone, causing acoustic feedback (howling sound).
Maximum recording time
You can record for up to 64 minutes in SP (standard play) mode and 150
minutes in LP (long play) mode. If you record messages in a mixture of SP
and LP modes, the recordable time varies from 64 to 150 minutes.
The unit is factory-set to SP mode. To change the recording mode, see page
35.
You can check the remaining amount of recording time by selecting the
remaining recording time display mode. See page 34.
12