Sony SPP-M932 - Manual (Page 35)

Troubleshooting (continued)
Symptom Remedy
LINE button lamp flashes when • Either the handset or the base phone is being used.
O.
E
to
not in use.
• The other telephone connected to the line is being
used.
c
o
V
3
• Make sure the telephone line cord is securely
connected to the telephone outlet.
UJ
z LINE 2 button lamp flashes
when not in use. • When you use only one line, this may happen if the
telephone is connected to the "LI or L1/L2" jack. In
this case, connect it to the "L2/DATA" jack.
0»
.£
You hear an error beep and
can't store a speed dialing • Make sure you follow the procedure in storing the
number correctly (page 19).
TD
TJ
0)
number.
• Make sure the number (including the tone and pause
digits) is fewer than 16 digits.
Q. Speed dialing is incorrect. • Store a correct number after a confirmation beep (page
19).
F
The handset doesn't ring when
calling from the base phone. • The battery may have little or no power. Charge the
battery for more than 8 hours (page 12).
o
w • Raise the antenna of the base phone vertically.
01
• Move the handset closer to the base phone.
• Place the base phone away from noise sources (page
8).
01
(0
The CHARGE lamp doesn't
light up when you replace the
handset to the base phone. • Wipe the charge terminals of the base phone and the
handset with a soft cloth or paper for better contact of
the charge terminals.
■««,
0>
u
k.
• Make sure the handset is placed on the base phone
properly.
0
*/t
0)
The battery pack has a shorter
life.
• The power wasn't continuously supplied to the base
phone.
$
o
Q.
• The battery pack was charged less than 8 hours (due
to power failure, etc.).
Additional Information