Sony SPP-M932 - Manual (Page 16)

Receiving calls on the base phone (speakerphone)
When you hear the phone ring,
press (
LINE 1 ) or ( LINE 2),
whichever button is flashing.
When you're done talking, press
(OFF).
(VOLUME t/-) The button goes off.
To Do this
Put a call on hold Press ( HOLD).
Press (LINE 1 ) or C LINE 2") to resume the
conversation.
Switch to another call on
the same line
("call waiting" service*) Press (LINE 1) or (LINE 2) tor the current call to
"FLASH" to the new caller.
Press the button again to get back to the first caller.
Adjust the speaker volume Press (VOLUME+/-) until the desired level is
reached.
Mute all calls Press ( MUTING) to disable the base phone
microphone.
The MUTING button lights up.
Press
( MUTING^ again to cancel.
’ Contact your telephone company to subscribe to this service.
To set ringer type, see page 21.
To obtain the best speakerphone performance
• You may not be able to hear the other party's" voice in a noisy place. Therefore, use
the speakerphone in a quiet room.
• Do not bring your hand or other objects too close to the microphone or you will
hear a shrill noise ("feedback").
• When the speaker volume is loud, or the telephone has been placed close to a wall,
you may find that the volume drops suddenly. This is due to a circuit in the
telephone designed to protect against feedback. In such cases, lower the speaker
volume slightly.
Note
The LINE 1 or LINE 2 button flashes in sets of two when the handset or another
extension is in use.
continued
Basics