Sony MDS-302 - Manual (Page 9)

Recording on MDs
Marking Track Numbers While
Recording (Track Marking)
You can mark track numbers either manually or
automatically. Bv marking track numbers at specific
points, vou can quickly locate the points later using the
AMS Function or Editing Functions,
To cancel Automatic Track Marking
1 Press EDIT/NO during recording or recording pause.
"l.eveiSync ?" appears in the display.
2 Press YES.
3 Press EDlT/NO.
"l.e\’elSyncCi)FE'' appears in the display.
* The signal leyel must remain low for 2 or mot-- seconds
before a new track number is written.
EDIT/NO YES • REC
oj3i II-
am-
diorBljl
Marking track numbers manually (Manual
Track Marking)
You can mark track numbers at any time while
recording on an MD.
Press • REC at the place you want to add a track mark
while recording.
'Q' When you want to mark track numbers after you've
done the recording
Use the Divide Function (sec "Dividing Recorded Tracks"
on page 20).
Marking track numbers automatically
(Automatic Track Marking)
The recorder adds track marks differently in the
following cases:
• When recording from CDs or MDs with INPUT at
DIGITAL and the source connected through
DIGITAL IN:
The recorder marks track numbers automatically.
When you record from a CD or MD, the track
numbers are written as they are found on the
original.
• When recording with INPUT at ANALOG and the
source connected through LINE IN, or when
recording from DAT with INPUT at DIGITAL and
the DAT connected through DIGITAL IN:
The recorder marks a new track number whenever
the signal level drops and rises to a certain point*
(Automatic Track Marking). If "LLVEL-SYNC" does
not light up, set the L-OvelSviic to ON as follows:
1 Press EDIT,/NO to display "Lev'clSvnc /"during
recording or recording pause.
2 Press YES twice to display "LevelSvnc ON."
"LEVLl.-SY'NC" appears in the display.