Sony MDS-302 - Manual (Page 11)

Recording on MDs
Recording on an MD Using a
Timer
You can start recording on an MD at a preset time hv
connecting a timer (not supplied). Please refer to the
instructions of the timer for further help.
TIMER
1 Insert a recordable MD.
2 Set the program selector on the amplifier to the
source you want to record.
3 Set TIMER on the recorder to REC.
4 Set the tinier to the time you want.
The recorder turns off. When the specified time
arrives, the recorder turns on and starts recording.
5 After you have finished using the tinier, set TIMER
on the recorder to OFF. Then either plug the AC
power cord ot the recorder into a wall outlet or set
the timer to continuous on so that the recorder stays
in standby status.
Make sure to change the recorder to standby status within
two or three days after timer recording is completed
When the recorder enters standby, the TCXf on the MD is
updated and the recorded contents are written to the MD. If
the recorder's standby status is off due to disconnection from a
power source for more than two or three days, the contents
recorded with llie timer may disappear.
If "STANDBY" flashes when you change the recorder to
standby status after timer recording is completed
The recorded conttmts ha\*e disappeared.
Notes
• II TIMER IS k'lt at REC, the recorder will automatically start
recording the next timi’ you turn the recorder on.
• During timiT recording, new material is recorded from the
f.'nd ot existing mati'rial on the Ml.).
• Matt'i'ial recoixitxl during timiT recording will be savt'd to
the disc the next time the reiorrier enters standby status.
" ГОС'" will tlash in the display at that time. Do not mox’e
the recorder or pull out tlu' ЛС power cord while "I'CX'" is
llashiig;.
• rimer ix'coixiine. will stoii it the disc brsomt's full.
11