Two Brothers Racing Front Fork Springs Honda CRF/XR50 - Manual (Page 3)

17. Now, re-install the front axle and tighten it using a 14mm
wrench on the rider's right and a 19mm on the rider's left.
18. Re-install the fork guards using a 5mm Allen wrench.
19. Take the supplied longer front-brake cable, and then route the
end with the notch on the cable back into the front-brake lever.
20. Route the bottom end of the brake cable through the fork
guard and then through the top tab on the fork tube. Then
replace the spring you removed in Step 4, route the threaded
end through the tab on the brake assembly, and then replace
the wing-nut to hold the brake in place.
21. Adjust the brake cable to the desired tension.
22. Carefully double check your work to insure that all hardware is
securely fastened.
NOTES:
Installation Instructions
010-6-30_fork-springs
3 of 3