Two Brothers Racing BMW R1200GS User Manual
V.a.l.e, R1200gs / gsa
V.A.L.E.
V a r i a b l e a x i s l o c k i n g e x h a u s t
TM
Installation Instructions
1.
Make sure the bike is completely cool before starting
the installation. Make sure the bike is secure on a
centerstand or ideally a service lift.
2.
Remove OEM muffler assembly by removing muffler
mount bolt and removing muffler tube joint clamp.
3.
Install supplied muffler mounting bracket using the
8x20mm bolt that is provided.
4. Loosely attach TBR slip-tube to TBR muffler using
the supplied two-part X-Ring and 6x20mm bolts
with lock washers. use supplied lock-tight.
5. Install TBR muffler assembly to motorcycle with the
rubber lined muffler clamp on muffler and barrel
clamp on slip-tube.
6. Attach muffler clamp to the previously installed
bracket using the supplied 8x16mm bolt and flange
nut. You can use the OEM washer for a different look.
7. Align muffler and tighten the muffler clamp bolt.
8. Check alignment and tighten X-Ring bolts then
barrel clamp.
9. Before you run the bike, clean off all fingerprints
and dirt, as any oily residue will etch the metal and
become somewhat permanent when the system
gets hot. Also, remove any protective plastic from
the name badges on the muffler canister(s) or the
muffler clamp(s). Run the bike and enjoy. It is normal
for some white smoke to appear the first time you
start the bike. This is packing/manufacturing oil from
inside the pipe burning off. After 50 to 100 miles,
recheck all fasteners for tightness.
2010-11 BMW
R1200GS / GSA
Slip-on Exhaust System
Part# 005-29804
IMPORTANT - PLEASE READ CAREFULLY
Warranty
two brothers racing products are intended for closed course competition purposes only, and therefore are sold “as is”
without warranty. two brothers racing specifically disclaims any warranties of merchantability or fitness for a particular
purpose and disclaims all responsibility for consequential and incidental damages or any other losses arising from the use
of these products or parts.
We recommend that this performance part be installed by a qualified motorcycle
technician. If you have any doubts as to your ability to install this performance
part, please consult with your local motorcycle dealer. Read all instructions first
before starting installation. Make sure the motorcycle and exhaust system are
completely cool before starting the installation. Also, make sure the bike is secure
on a centerstand or ideally a service lift during installation. Be sure to save all stock
components for possible use later.
**This product has not been tested with all available accessories and some
items may cause excessive heat. Excessive heat may cause damage to your
vehicle. Two Brothers Racing will not be responsible for damaged parts.