Two Brothers Racing Suzuki LTR450 Coil Kit - Manual (Page 2)

wire to the unmarked ignition coil terminal.
11) Plug the sparkplug wire boot onto the coil output tower, push the rubber boot onto the coil tower to eliminate any gap as
this is a potential source of high-voltage arcing.
12) Install the Coil to the stock location, adjust Dyna coil for any clearance issues.
13) Route the sparkplug wire in the stock location, if the sparkplug wire is too long, then cut it to the proper length.
14) Press in and screw the stock sparkplug boot onto the Dynatek supplied sparkplug wire. Screw it in clockwise until it is
bottomed out.
15) Check the wiring, make sure connections are tight and secure.
16) Tighten all coil mounting bolts, install gas tank in the reverse order.
17) Start the engine. Installation is complete!
2801304A REV. 8-09-06