Two Brothers Racing Suzuki LTR450 Coil Kit User Manual
Dynatek coil kit dck3-1
Dynatek Coil Kit DCK3-1
2006+ Suzuki LT-R450
Congratulations on your purchase of a Dynatek Ignition Coil Kit. Please take a moment to read these instructions completely before
installing the ignition coil. The installation will only take about 30 minutes.
This kit includes: Dynatek Ignition 0.5ohm Mini-Coil
Spark plug wire, terminal and boot
Electrical
plug-in
wiring
adaptor
Coil mounting “Z” bracket, bolt, lock nuts & washers
This is a complete kit, and includes everything needed to install the ignition coil.
Note: The stock sparkplug boot will be reused in this application.
Note: The fuel tank will have to be removed to gain access to the sparkplug boot.
Note: Route all wires carefully. Secure wires in factory loops or use cable ties to ensure electrical wires do not chafe or touch anything
hot. Pay close attention to the wiring detail and wire crimping, successful installation depends on this.
Tools Required:
10mm, 12mm, and 14mm socket wrench
10mm
combination
wrench
5mm
Allen
wrench
Installation
1)
Turn ignition key off.
2)
Remove the gas tank, to gain access to the sparkplug boot. Remove sparkplug boot from the sparkplug.
3)
Disconnect the stock coil primary wires at the 2-position blue connector.
4)
Remove the two 12mm coil bracket-to-frame mounting bolts.
5)
Remove the 14mm coil bracket-to-engine mounting bolt. Be careful not to drop the washer behind this bracket.
6)
Remove the stock ignition coil and bracket from the ATV. Remove the coil from the bracket by removing the two 10mm
nuts from the two 5mm Allen bolts.
7)
Remove the stock spark plug boot from the sparkplug wire. Hold the sparkplug wire near the boot and unscrew the boot
counterclockwise.
8)
Set aside: Stock coil and wire(minus the rubber cap), the Allen bolts, spacers and nuts.
9)
Mount the supplied “Z” bracket to the Dynatek ignition coil. Bolt the original black coil bracket to the coil assembly,
using the supplied 55mm bolt, spacer, washers and lock nut. See picture:
10)
Connect the Black ground adaptor wire to the ignition coil terminal with the RED DOT, and connect the White adaptor