Two Brothers Racing Kawasaki KX450F - Manual (Page 4)

ITBR001-236 www.twobros.com 2009-2010 Kawasaki KX450F - 4
Figure D
Figure E
8. Locate the Throttle Position Sensor (TPS) connector.
The TPS connector is a white 3-pin connector located behind the throttle body as
shown in Figure D. It is best accessed from the right side of the bike.
Figure D was taken from the left side of the bike between the frame and air box.
9. Unplug the TPS connector.
10. Attach the connectors from the Juice Box Pro to the stock TPS connector and the
stock wiring harness as shown in Figure E.
ground wire
11. Remove the upper bolt securing the ignition coil to the frame.
12. Attach the ground wire from the Juice Box Pro to the frame using this bolt shown
in Figure F.
13. Reinstall the fuel tank.
Verify the Juice Box Pro harness does not get pinched.
14. Reinstall the front number plate.
15. Reinstall the seat.
Figure F
stock connectors
Juice Box Pro
connectors
unplug TPS
connector