Two Brothers Racing Kawasaki KFX450R - Manual (Page 4)

iTBR001-166 2008-10 Kawasaki KFX450R - 4
Fi
gu
re
D
Fi
gu
re
E
Fi
gu
re
F
ground wire
unplug TPS
8 Attach the Juice Box Pro wiring harness to the injector and the stock wiring harness
as shown in Figure D.
9 Remove the bolt securing the stock ground wire to the frame.
10 Attach the ground wire from the Juice Box Pro to this same location as shown in
Figure D.
11 Locate the stock throttle position sensor (TPS) connector on the left hand side of the
throttle body.
12 Unplug the stock wiring harness from the TPS as shown in Figure E.
This allows access to the wiring harness.
13 Crimp the supplied wire tap to the yellow/white wire as shown in Figure F.
14 Attach the grey wire from the Juice Box Pro to the wire tap as shown in Figure F.
Note:It is recommended to use dielectric grease on both of these connections.
15 Attach the TPS connector to the throttle bodies.