Two Brothers Racing Honda CBR1000RR - Manual (Page 3)

ITBR001-181 2006-07 Honda CBR1000RR - 3
Fi
gu
re
A
Fi
gur
e B
Fi
gu
re
C
remove
these bolts
Juice Box Pro
harness
Juice Box Pro
harness
Juice Box Pro
harness
remove this
bracket
Juice Box Pro
harness
The ignition must be turned OFF before installation.
1 Remove the main seat and the passenger seat.
2 remove the fuel tank cover.
3 remove the two bolts for the rear tail section as shown in Figure A.
4 Remove the left hand side mid fairing.
5 Temporarily lay the Juice Box Pro in the tail section.
6 Route the Juice Box Pro harness towards the front of the bike.
Keep the harness between the outside of the sub-frame and inside the tail section as
shown in Figure B.
7 Gently pull out on the lower left hand side of the tail section to allow room for the
harness.
8 Route the harness between the battery and the sub-frame and go towards the
throttle bodies.
9 Remove the fuel tank stop bracket to route the Juice Box Pro harness underneath it
as shown in Figure C.