Two Brothers Racing BMW K1300S User Manual
Page 5
ITBR001-265
2009-2010 BMW K1300S - 5
Fi
g
u
re
G
Fig
u
re H
Fig
u
re I
ground wire
unplug stock
O2 sensor
8
Reinstall the fuel rail.
9
Reinstall the air box.
Note:Verify the Juice Box Pro ground wire is pulled towards the outside of the
frame.
10 Route the Juice Box Pro ground wire along the stock ground wire.
11 Attach the ground wire from the Juice Box Pro to the negative side of the battery as
shown in Figure G.
12 Using the supplied velcro, secure the Juice Box Pro in the tail section as shown in
Figure H.
Make sure to clean both surfaces with the alcohol swab before attaching.
The Juice Box Pro can also be mounted under the black cover near the fuel tank cap.
13 Unplug the stock O2 sensor from the main wiring harness as shown in Figure I.
The O2 sensor connector is located under the fuel tank near the ABS control. The O2
sensor will no longer be connected to anything. The sensor can be removed from
the exhaust if desired.
14 Verify all the electronics are securely connected before trying to start the
motorcycle.
15 Reinstall the fuel tank and bodywork.