Two Brothers Racing M2R MX - Manual (Page 2)

11. Align P-tip so that the slant is facing up. Re-install endcap
and torx bolts, tighten in a cross pattern.
12. If your sticker badge is beaten up, you can remove it and
clean the surface using brake clean and the provided rag,
re-install the sticker as shown.
13. Double check to make sure that all hardware is tightened.
14. Before you run the bike, clean off all fingerprints and
dirt, as any oily residue will etch the metal and become
somewhat permanent when the system gets hot. Run
the bike and enjoy. Check for gaps or leaks. After first
ride, recheck all fasteners for tightness.
V.A.L.E.
V a r i a b l e a x i s l o c k i n g e x h a u s t
TM
2010 M2R MX
Repack kit
High temp Fiber kit
part # 005-99-R12, 005-99-R14, 005-99-R15
Installation Instructions
9. Re-install smaller sized wave-washer then thread the
core nut on, and use core nut tool with 27mm socket and
tighten to 30lb-ft torque.
10. Re-install P-tip (with spark arrestor if applicable). Install
Larger wave-washer on top of the P-tip if you are not
using spark arrestor. There always needs to be 2 pieces
under the endcap whether it is p-tip and washer, p-tip
and spark arrestor, spark arrestor and washer, or none at
all. See Diagram.