Two Brothers Racing Kawasaki ZX-10R - Manual (Page 2)

V.A.L.E.
V a r i a b l e a x i s l o c k i n g e x h a u s t
TM
Installation Instructions
Tighten barrel clamp.
Install TBR fender eliminator kit using the 4 6x14mm
S.H.C.S. and supplied nuts to rear frame.
Attach turn signals and plate light bolts using the wire
splice connectors supplied to the correct wires in the
harness as shown in the Wiring Diagram.
14.
15.
16.
Warranty
two brothers racing products are intended for closed course competition purposes only, and therefore are sold “as is”
without warranty. two brothers racing specifically disclaims any warranties of merchantability or fitness for a particular
purpose and disclaims all responsibility for consequential and incidental damages or any other losses arising from the use
of these products or parts.
WIRING DIAGRAM
Lef
t Tu
rn
Sig
nal
(Gr
ey
con
nec
tor
)
R
ed
Plate Lights
Righ
t Turn
Sign
al
(Blac
k con
necto
r)
Wiring Harness
Blac
k/Y
ellow
Red
Blac
k Blac
k
Red
2008 Kawasaki
ZX-10R
V.A.L.E.™ Full Exhaust System with M-2 Canister
Part # 005-1990106V, 005-1990107V, 005-1990108V
Start engine and make sure no leaks are found.
Re-install seats and covers.
Check for clearance between exhaust and all other parts and
make adjustments if needed.
Double check all your work.
Before you run the bike, clean off all fingerprints and dirt, as
any oily residue will etch the metal and become somewhat
permanent when the system gets hot. Also, remove any
plastic film from the name badge(s) and or canister clamp(s).
Run the bike and enjoy. It is normal for some white smoke
to appear the first time you start the bike. This is packing/
manufacturing oil from inside the pipe burning off. Check
for gaps or leaks. If you find a leak, a little high temperature
silicon sealant should fix it. After 50 to 100 miles, recheck all
fasteners for tightness.
* For best overall performance a JuiceBox (008-199) should
be used.
17.
18.
19.
20.
21.