Two Brothers Racing Honda CBR600RR - Manual

IMPORTANT - PLEASE READ CAREFULLY
Two Brothers Racing products are intended for closed course competition
purposes only.
We recommend that this performance part be installed by a qualified
motorcycle technician. If you have any doubts as to your ability to install
this performance part, please consult with your local motorcycle dealer.
Read all instructions first before starting installation. Be sure to save all
stock components for possible use later.
This product was designed for use with no aftermarket or O.E.M.
accessories installed. Any modifications or installation of aftermarket
accessories may cause excessive heat and could result in the damage
of the vehicle. Two Brothers Racing will not be responsible for damaged
parts due to heat related issues.
Installation Instructions
1. Make sure the bike is completely cool before starting
the installation. Make sure the bike is secure on the side
stand or ideally a rear service stand.
2. Remove passenger seat and main seat.
3. Remove bolts from rear cowling and slide cowling back.
4. Disconnect modular connector on the left side of the
bike leading to the rear fender assembly.
5. Remove the rear fender assembly bolts and slip the rear
fender assembly back and remove.
6. Remove the side bolt and one top bolt securing the heat
shield.
7. Remove right side plastic cover from over exhaust tube
heat shield.
8. Remove bolt securing lower end of exhaust tube heat
shield (above driver’s right foot peg mount).
9. Remove right side passenger foot peg.
Honda
CBR600RR
V.A.L.E.™ Full Exhaust System with M-2 Canister
Part # 005-36701