Taylor-Wharton 24K w/ AutoTend - Manual (Page 41)

should direct vent gases out the back of the lid and away from the controller.
•
Adjust lid hinges and/or replace gasket.
2. Check seal between top of tub and beige cabinet top. The black gasket should
prevent venting under the cabinet top.
3. Check seal around sensor wires. Tape or spray foam this gap if needed.
Message “Please Wait”
A circuit board malfunction has occurred. Call your authorized Taylor-Wharton agent
for assistance.
Display = “Check”
The word CHECK will flash during periods of Splash-Guard protection. See page 18
for more information.
Lid Open Alarm
A lid switch is located on the left rear hinge. The switch lever should actuate when the
hinge is opened and again when it is shut.
1. Confirm that the two spade connectors are connected to the back of the switch.
They should be attached to the “G” and the “N/C” connections.
2. The switch can be bumped or moved during shipment. Adjust switch up until
closed hinge will actuate switch lever.
QCF (Quick Chill Feature) Will Not Operate
See LID OPEN ALARM
1. To activate or adjust times: Select MENU, USER OPTIONS, CONTROL OP-
TIONS, LID/DEFOG SETTINGS, QUICK CHILL.
Defog Feature Will Not Operate
See LID OPEN ALARM.
1. To activate or adjust times: Select USER OPTIONS, CONTROL OPTIONS, LID/
DEFOG SETTINGS, AUTO DE-FOG.
Push Buttons Will Not Respond
1.
Check all ribbon cable connectors on back of display panel.
2. Moisture may have migrated into the sealed faceplate. Call Taylor-Wharton for a
Return Authorization.
Liquid Level Readout is Incorrect
Liquid level is determined by a seven thermistor assembly inside a protective sensor
tube. The user may adjust the desired START FILL elevations and STOP FILL
elevations for the pool of nitrogen with the confines of the eight inches. The EX-LOW
LEVEL ALARM is automatically assigned to the thermistor below the START FILL
assignment, and the EX-HIGH LEVEL ALARM automatically reserves the thermistor