Eagle Electronics 502C - Manual (Page 96)

90
Overlay Data Shown, with Date option selected (left). Press ENT to ac-
cess R
EMOVE
option (center). Press ENT again to remove item and return
to Overlay Data Shown (right).
To move overlaid data:
You may find it useful to rearrange data that is floating in your display
window.
1. From one of the Map Pages, press MENU |
↓ to
O VERLAY D ATA
| ENT .
2. You'll see a list of the overlay data currently displayed. Select the
item you want to move and press
ENT |
→ to
M
OVE
| ENT .
3. The data begins to flash on your screen. Use any combination of
→,
←, ↑ and ↓ to move the data to a new location on the screen.
4. When satisfied, press EXIT | EXIT .
NOTE:
The Customize command and the Overlay Data command both use
the same information categories. The difference between the two
commands is that Customize changes only the data boxes on your
display, and Overlay Data floats information anywhere on the
screen. See Customize Page Displays, on page 74, for information
on customizing data boxes.
Pop-up Help
Help is available for virtually all of the menu labels on this unit. By
highlighting a menu item and leaving it highlighted for a few seconds, a
"pop-up" message appears that describes the function of the menu item.
This feature is on by default.
To set up Popup Help: Press MENU | MENU |
↓ to
S YSTEM S ETUP
| ENT |
↓
to P OPUP H ELP
. With the option highlighted, press ENT to check it (turn
on) and uncheck it (turn off.) After the option is set, press EXIT | EXIT to
return to the page display.