Eagle Electronics 502C - Manual (Page 21)

15
options; accessory ordering information is on the inside back cover of this
manual. For a complete look at the many mounting options, visit the RAM
web site at www.ram-mount.com.
Optional R-A-M mounting system.
Bracket Installation
Mount the IntelliMap 502C in any convenient location, provided there is
clearance behind the unit when it's tilted for the best viewing angle. This
must be in a location with a clear view of the sky, so the internal
GPS antenna can lock-on to the satellite signals. You should also
make sure there is enough room behind the IntelliMap 502C to attach the
power cable. (a drawing on the next page shows the dimensions of a gim-
bal-mounted IntelliMap 502C.)
Holes in the bracket's base allow wood screw or through-bolt mounting.
You may need to place a piece of plywood on the back side of thin fiber-
glass panels to reinforce the panel and secure the mounting hardware.
Install the gimbal bracket. Orient the bracket so the arms slope
toward the front of your unit.
Drill a 1-inch (25.4 mm) hole in the dash for the power cable. The best
location for this hole is immediately under the gimbal bracket location.
This way, the bracket can be installed so that it covers the hole, holds
the cable in position and results in a neat installation. Some customers,
however, prefer to mount the bracket to the side of the cable hole — it's
a matter of personal preference.
Front