Dell PowerEdge RAID Controller H710 - Manual (Page 25)

3
Deploying The PERC Card
CAUTION: Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your
warranty. Read and follow the safety instructions that came with the system.
NOTE: For information on removing and reinstalling system parts, see the Owner's Manual of the system at
dell.com/support/manuals.
NOTE: For more information on your storage controller, see the relevant storage controller documentation at
dell.com/support/manuals.
This document provides a set of high level installation and removal instructions for the following Dell PowerEdge RAID
Controllers (PERC):
• PERC H310 Adapter
• PERC H310 Mini Monolithic
• PERC H310 Mini Blade
• PERC H710 Adapter
• PERC H710P Adapter
• PERC H710 Mini Monolithic
• PERC H710P Mini Monolithic
• PERC H710 Mini Blade
• PERC H710P Mini Blade
• PERC H810 Adapter
Removing The PERC Controller
To remove the PERC controller:
1. Perform a controlled shutdown of the system and attached peripherals.
2. Disconnect the system from the electrical outlet and remove the system cover.
3. Remove the storage controller from the PCIe slot of the system.
CAUTION: When removing or replacing the PERC Mini Monolithic Controller, hold the card by its edges
marked by the blue touch points. Do not handle the card while holding the battery or the heatsink.
For more information, see to the relevant figures below.
25