Replacing the processor, Removing the processor – Dell XPS 730x (Early 2009) User Manual

Page 45

Replacing the Processor: Dell XPS 730/730X Service Manual

file:///C|/Users/santhosh_v/Desktop/7/SM_en/processo.htm[9/5/2013 11:46:41 AM]

Replacing the Processor

Dell™ XPS™ 730/730X Service Manual

Removing the Processor

WARNING:

Before working inside your computer, read the safety information that shipped with your

computer. For additional safety best practices information, see the Regulatory Compliance Homepage at

www.dell.com/regulatory_compliance.

CAUTION:

Do not perform the following steps unless you are familiar with hardware removal and

replacement. Performing these steps incorrectly could damage your system board. For technical service,

see the Setup Guide.

1. Follow the procedures in

2. Remove the computer cover (see

WARNING:

Despite having a plastic shield, the heat sink assembly may be very hot during normal

operation. Be sure that it has had sufficient time to cool before you touch it.

3. Disconnect the power cables from the ATX_POWER and ATX_CPU connectors (see

) on the

system board.

4. Remove the processor fan and heat sink assembly from the computer (see

NOTE:

Unless a new heat sink is required for the new processor, reuse the original heat sink assembly when you

replace the processor.

5. Press and push the release lever down and out to release it from the tab that secures it.

6. Open the processor cover, if applicable.

Removing the Processor