Dell OptiPlex GX110 - Manual (Page 67)

See the User's Guide for detailed information on the chassis intrusion detector.
DIMMs
Figure 25. DIMM Removal
To remove a DIMM, perform the following steps:
1. Push outward on the two DIMM socket ejectors simultaneously until the DIMM is released from its socket.
2. Lift the DIMM away from the socket.
To install a DIMM, press the DIMM fully into the socket while closing the ejectors to lock the DIMM into the socket (see Figure 26).
Figure 26. DIMM Installation
Microprocessor/Heat Sink Assembly
Figure 27. Microprocessor/Heat Sink Assembly Removal
NOTE: If a setup password has been assigned by someone else, contact your network administrator for information on resetting the
chassis intrusion detector.
1 Ejectors (2)
CAUTION: Use a wrist grounding strap as explained in " Precautionary Measures ."
1 Ejectors (2)
2 Notches (2)
1 Fan
2 Guide bracket assembly
3 Guide bracket assembly latch
4 Heat sink
CAUTION: The microprocessor single edge contact (SEC) cartridge/heat sink assembly can get extremely hot. Be sure that
the assembly has had sufficient time to cool before you touch it.