Dell Latitude D620 ATG - Manual (Page 13)

3. Use a plastic scribe to pry the six rubber screw covers/display bumpers out of the screw holes on the front of the bezel.
4. Remove the six M2.5 x 5-mm shoulder screws from the front of the bezel.
5. Starting from the inside edges of the bezel, use your fingers to gently pry the bezel upward and outward from the display panel.
Removing the Display Panel
1. Follow the instructions in Before You Begin .
2. Remove the display assembly (see Display Assembly ).
3. Remove the display bezel (see Removing the Display Bezel ).
4. Remove the three M2 x 3-mm screws from each side of the display panel.
NOTICE: Carefully separate the bezel from the display back cover to avoid damage to the bezel.
1 screw covers/display bumpers (6) 2 M2.5 x 5-mm shoulder screws (6) 3 display bezel
4 display panel 5 display back cover
NOTICE: To avoid damaging the computer when replacing the display bezel, ensure that the bezel edges line up with those on the display back cover,
and snap into place around the entire perimeter of the display back cover.
CAUTION: Before working inside your computer, follow the safety instructions in the Product Information Guide.
CAUTION: To prevent static damage to components inside your computer, discharge static electricity from your body before you touch any of
your computer's electronic components. You can do so by touching an unpainted metal surface.
1 display panel 2 M2 x 3-mm screws (6) 3 display back cover