Dell PowerEdge 400SC User Manual
Page 14

1.
Enter System Setup (see "
Entering the System Setup Program
") and verify that Password Status is set to Unlocked.
2.
Highlight System Password and then press the left- or right-arrow key.
The option heading changes to Enter Password, followed by an empty 32-character field in square brackets.
3.
Type your new system password.
You can use up to 32 characters. To erase a character when entering your password, press
case sensitive.
Certain key combinations are not valid. If you enter one of these combinations, the system emits a beep.
As you press each character key (or the spacebar for a blank space), a placeholder appears in the field.
4.
Press
If the new system password is less than 32 characters, the whole field fills with placeholders. Then the option heading changes to Verify Password,
followed by another empty 32-character field in square brackets.
5.
To confirm your password, type it a second time and press
The password setting changes to Enabled.
6.
Exit System Setup.
Password protection takes effect when you restart the computer.
Typing Your System Password
When you start or restart the system, one of the following prompts appears on the screen.
If Password Status is set to Unlocked:
Type in the password and
- press
- press
Enter password:
If Password Status is set to Locked:
Type the password and press
If you have assigned a setup password, the system accepts your setup password as an alternate system password.
If you type a wrong or incomplete system password, the following message appears on the screen:
** Incorrect password. **
If you again type an incorrect or incomplete system password, the same message appears on the screen. The third and subsequent times you type an
incorrect or incomplete system password, the system displays the following message: