Expansion cards – Dell OptiPlex GX200 User Manual
Page 30
Expansion Cards
The system accommodates up to six expansion cards, including up to five 32-bit PCI expansion cards and one 32-bit AGP card. (See
for examples of these cards.)
Figure 16. Expansion Cards
Expansion-Card Removal
To remove an expansion card, perform the following steps:
1.
.
2. Remove the expansion-card cage.
3. If necessary, disconnect any cables connected to the card.
4. Unscrew the mounting bracket of the card you want to remove.
CD_IN
CD-ROM audio interface connector
RIMM_x
RIMM socket
DSKT
Diskette/tape drive interface connector
ENET
Integrated NIC connector
EXT_SPKR
External speaker connector
FAN
Microprocessor fan connector
HDLED
Hard-disk drive LED connector
IDEn
EIDE interface connector
INTRUDER
Chassis intrusion switch connector
KYBD
Keyboard connector
MODEM
Modem audio connector
MONITOR
Video connector
MOUSE
Mouse connector
PANEL
Control panel connector
PARALLEL
Parallel port connector; sometimes referred to as LPT1
PCIn*
PCI expansion-card connector
POWER_1
Main power input connector
POWER_2
3.3-V power input connector
RISER
Riser board connector
SERIALn
Serial port connector
SLOT1_PRI
Primary microprocessor connector
USB
USB connectors
NOTES: Before disconnecting a peripheral from the system or removing a component from the system board, verify that the standby
power LED on the system board is off. For the location of this LED, see
1 8-bit ISA expansion card
2 16-bit ISA expansion card
3 32-bit PCI expansion card