Dell POWEREDGE M1000E - Manual (Page 19)

Fabric OS v6.4.1 Release Notes v1.0 Page 19 of 62
Power Supply Requirements for B Power Supply Requirements for B Power Supply Requirements for B Power Supply Requirements for Blades in 48k and DCX/DCX lades in 48k and DCX/DCX lades in 48k and DCX/DCX lades in 48k and DCX/DCX----4S Chassis 4S Chassis 4S Chassis 4S Chassis
Blades Blades Blades Blades Type of Type of Type of Type of
Blade Blade Blade Blade
48K 48K 48K 48K
@200-240
VAC
(Redundant
configurations)
DCX/DCX DCX/DCX DCX/DCX DCX/DCX----4S 4S 4S 4S
@110 VAC
(Redundant
configurations)
DCX/DCX DCX/DCX DCX/DCX DCX/DCX----4S 4S 4S 4S
@200-240 VAC
(Redundant
configurations)
Comments Comments Comments Comments
redundant
configuration with any
number of FS8-18
Blades.
• For both DCX and
DCX-4S with FX8-24
blades, (1+1) 220VAC
Power Supplies are
required for
redundancy.
FOS Feature Compatibility in Native Connectivity Modes FOS Feature Compatibility in Native Connectivity Modes FOS Feature Compatibility in Native Connectivity Modes FOS Feature Compatibility in Native Connectivity Modes
Some FOS features are not fully supported when operating in the native connectivity modes for deployment
with M-EOS based products. All Brocade models that are supported by Fabric OS v6.4 support both
interopmodes 2 and 3 with the exception of the Brocade 4100 and 8000 and DCX/DCX-4S with one or more
FCOE10-24 blades.
The following table specifies the support of various FOS features when operating in either interopmode 2
(McDATA Fabric Mode) or interopmode 3 (Open Fabric Mode) with Fabric OS v6.4
.
FOS Features FOS Features FOS Features FOS Features (supported in interopmode 0) FOS v6.4 FOS v6.4 FOS v6.4 FOS v6.4
IM = Interopmode IM = Interopmode IM = Interopmode IM = Interopmode IM 2 IM 2 IM 2 IM 2 IM 3 IM 3 IM 3 IM 3
L2 FOS Hot Code Load Yes Yes
FOS Hot Code Load with FCR Yes Yes
Zone Activation Support Yes Yes 11
Traffic Isolation Zones 1 Yes No
Frame Redirection (devices attached to FOS) 1 Yes Yes 11
Frame Redirection (devices attached to M-EOS) 1 Yes Yes 11
Frame Redirection over FCR 10 Yes Yes 11
FCR Fabric Binding (route to M-EOS fabric with Fabric binding) 9 Yes Yes
L2 Fabric Binding Yes No*
DCC policies No No
SCC policies Yes 4 No*
E/EX_Port Authentication Yes Yes
ISL Trunking (frame-level) Yes 2 Yes 2
Dynamic Path Selection (DPS, exchange based routing) Yes 3 Yes 3
Dynamic Load Sharing (DLS, port based routing) Yes Yes
Virtual Channels (VC RDY) Yes 2 Yes 2
FICON Management Server (Cascading) Yes No*
FICON MIHPTO Yes No*
Full Scalability (to maximum M-EOS fabric limits) Yes Yes