Dell POWEREDGE M1000E - Manual (Page 60)

Closed with Code Change in Fabric OS v6.4.0a
Fabric OS v6.4.1 Release Notes v1.0 Page 60 of 62
Defect ID: DEFECT000281212 Technical Severity: Medium
Summary: In AG mode, N-Port failover results in F-Ports with attached hosts getting stuck as G_Port
Symptom: F-Ports get stuck as G-Ports after AG N-Port failover.This happens when there is a change in
the base address for the N-Port due to failover, or when there is no wwn-area mapping for
few devices and due to the login sequence of these devices, the PIDS assigned conflicted
with the already allocated PID to another device, resulting in the F-Ports getting stuck as G-
Port.
Workaround: portdisable/enable
Feature: Embedded Platform Services Function: Other
Probability: Medium
Found in Release: FOS6.2.0_bc
Defect ID: DEFECT000286529 Technical Severity: Medium
Summary: FICON: when CHPs are very busy, CUP may report many IFCCs
Symptom: IFCCs on CUP exchange
Feature: Field Escalation Function: FICON
Probability: Low
Found in Release: FOS6.3.0
Defect ID: DEFECT000288968 Technical Severity: Medium
Summary: When running 200 ms delay and 1% packet loss, after 4 days of run time, an IPSec
enabled FCIP circuit bounced.
Symptom: Tunnel bounce can occur.
Feature: FCIP Function: FCIP Port
Probability: Low
Found in Release: FOS6.4.0
Defect ID: DEFECT000289418 Technical Severity: Medium
Summary: Tape drives fail when running over FCR with EX ports in Open mode. The REC accept
payload is incorrect.
Symptom: If host to tape I/O traverses FCR and includes an edge fabric, the tape drives would run for
a bit and then fail due to REC ACC is not processed correctly if EX port is operating in
IM3/Open mode.
Feature: Legacy FCR - 7500/FR4-18i Function: FCR Daemon
Probability: High
Found in Release: FOS6.3.0 Service Request ID: 419137