Dell Inspiron 17R (N7110, Early 2011) User Manual

Page 87

Processor Module

NOTE:

If a new processor is installed, you will receive a new thermal-cooling

assembly, which will include an affixed thermal pad, or you will receive a new

thermal pad along with documentation to illustrate proper installation.

2 Align the pin-1 corner of the processor module with the pin-1 corner of the

ZIF socket, then insert the processor module.

NOTE:

The pin-1 corner of the processor module has a triangle that aligns with the

triangle on the pin-1 corner of the ZIF socket.

When the processor module is properly seated, all four corners are aligned

at the same height. If one or more corners of the module are higher than

the others, the module is not seated properly.

CAUTION:

To avoid damage to the processor, hold the screwdriver perpendicular

to the processor when turning the cam screw.

3 Tighten the ZIF socket by turning the cam screw clockwise to secure the

processor module to the system board.

4 Replace the thermal cooling assembly (see "Replacing the Thermal

CAUTION:

Before turning on the computer, replace all screws and ensure that no

stray screws remain inside the computer. Failure to do so may result in damage to
the computer.

book.book Page 87 Friday, April 13, 2012 2:02 PM