Dell PowerEdge 6650 - Manual (Page 9)

Back to Contents Page
Installing and Configuring SCSI Drivers
Dell™ PowerEdge™ 6650 Systems User's Guide
The SCSISelect Utility
This section describes how to install and configure the SCSI device drivers included with your system. These device drivers are designed to work with the SCSI
controller on the system board. The SCSI channel is available for internal or external tape backup devices.
If you are using an optional RAID controller, see your RAID controller documentation for information on installing your SCSI device drivers.
For instructions on installing hardware devices such as diskette drives, CD drives, and tape drives, see "Installing Drives" in the Installation and Troubleshooting
Guide. After the SCSI devices are installed, install and configure any SCSI device drivers to enable them to communicate with your operating system.
SCSI device drivers are provided for the following operating systems:
l Microsoft® Windows NT® Server 4.0
l Windows NT Server 4.0, Terminal Server
l Windows NT Server 4.0, Enterprise Edition
l Microsoft Windows® 2000 Server and Advanced Server
l Red Hat Linux 7.2 or later
l Novell® NetWare® 6.0
See " Using the Dell OpenManage Server Assistant CD " for instructions on creating a diskette of drivers for your operating system. For instructions on
configuring the SCSI device drivers, see the documentation that came with your operating system. You may also need to use the SCSISelect utility, discussed
in this section.
The SCSISelect Utility
The BIOS for your system's integrated SCSI controller includes the menu-driven SCSISelect configuration utility, which allows you to change SCSI controller
settings without opening the system. SCSISelect also contains SCSI disk utilities that let you perform a low-level format or verify the disk media of your SCSI
hard drives.
Starting the SCSISelect Utility
You can start the SCSISelect utility by pressing when the following prompt appears briefly during start-up:
Press for SCSISelect™ Utility!
The first menu displays the Configure/View Host Adapter Settings and SCSI Disk Utilities options.
Using SCSISelect Menus
SCSISelect uses menus to list options that you can select. To select an option, press the up- and down-arrow keys to move the cursor to the option, and then
press .
In some cases, selecting an option displays another menu. You can return to the previous menu at any time by pressing . To restore the original
SCSISelect default values, press .
SCSISelect Default Settings
Default settings for the integrated SCSI controller are shown in Table C -1 . These default settings are appropriate for most PCI systems. Run SCSISelect only if
you need to change any of the default settings.
For situations in which you might want or need to change the settings, see the description of each setting in the following subsections. To change any of the
default settings or to format or verify a disk, see "
Using the SCSI Disk Utilities ."
NOTE: To change the configuration settings, you must run the SCSISelect utility.
Table C-1. AIC-7892 SCSI Controller Settings
Setting Default
SCSI Bus Interface Definitions:
Host Adapter SCSI ID 7
SCSI Parity Checking Enabled
Host Adapter SCSI Termination Enabled
Boot Device Options:
Boot Channel A First
Boot SCSI ID 0