Dell OptiPlex GX1 User Manual
Page 79
Installing Drives: Dell OptiPlex GX1 Low-Profile Managed PC Systems
file:///C|/infodev/2013/eDoc/OpGX1/SQRG/drives.htm[2/21/2013 11:53:04 AM]
Use the score marks on the drive bracket to help align the screw holes on the drive with the screw
holes on the bracket (see Figure 8).
Figure 8. Installing the 5.25-Inch Diskette Drive Bracket
To further ensure proper positioning of the drive in the chassis, insert and tighten all four screws in the
order in which the holes are numbered (the holes are marked "1" through "4").
6. Reinstall the 5.25-inch drive/bracket assembly in the chassis.
Align the notches on the front of the drive bracket (see
) with the front of the computer. Hold
the bracket level, and lower the assembly straight down into place (see Figure 9).
Figure 9. Inserting the Drive into the Drive Bay
7. If you are installing a drive that has its own controller card, install the controller card in an expansion
slot.
See "
."
8. Connect a DC power cable to the power input connector on the back of the drive (see
NOTICE: You must match the colored strip on the cable with pin 1 on the drive's interface
connector to avoid possible damage to your system.
9. Connect the appropriate interface cable to the interface connector on the back of the drive (see
If your system came with an EIDE CD-ROM or tape drive, use the spare connector on the existing
interface cable. Otherwise, use the EIDE interface cable provided in the drive kit.