System board, Removing the system board, Replacing the system board – Dell Latitude E6410 User Manual
Page 48
Back to Removing and Replacing Parts
System Board
Dell™ Latitude™ E6410/E6410 ATG Service Manual
Removing the System Board
1.
Follow the procedures in
Before Working Inside Your Computer
.
2.
Remove the
ATG port cover
(applicable on E6410 ATG computer only).
3.
Remove the
battery
.
4.
Remove the
SIM card
.
5.
Remove the
SD card
.
6.
Remove the
ExpressCard
.
7.
Remove the
Smart card
.
8.
Remove the
hinge covers
.
9.
Remove the
access panel
.
10.
Remove the
optical drive
.
11.
Remove the
hard drive
.
12.
Remove the
LED cover
.
13.
Remove the
keyboard
.
14.
Remove the
coin-cell battery
.
15.
Remove the
memory
.
16.
Remove the
WWAN card
.
17.
Remove the
WLAN card
.
18.
Remove the
Latitude ON™ Flash/CMG module
.
19.
Remove the
Fingerprint Reader
.
20.
Remove the
Heat Sink and Processor Fan
.
21.
Remove the
Display Assembly
.
22.
Remove the
palm rest
.
23.
Disconnect the power connector from the system board.
24.
Disconnect the smart card reader and IEEE 1394 cables from system board.
25.
Remove the screws that secure the system board to the computer.
26.
Starting in the back right corner and separate the system board from the I/O board connector.
27.
Lift the back edge of the system board until all the connectors on the left side are separated and slide the system board towards the rear and remove
from the computer.
Replacing the System Board
To replace the system board, perform the above steps in reverse order.
Back to Removing and Replacing Parts
WARNING:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
NOTE:
You may need to install Adobe® Flash® Player from Adobe.com in order to view the illustrations below.