Ieee 1394 port, Removing the ieee 1394 port, Replacing the ieee 1394 port – Dell Latitude E6410 User Manual
Page 31
Back to Removing and Replacing Parts
IEEE 1394 Port
Dell™ Latitude™ E6410/E6410 ATG Service Manual
Removing the IEEE 1394 Port
1.
Follow the procedures in
Before Working Inside Your Computer
.
2.
Remove the
ATG Port Cover
(applicable on E6410 ATG computer only).
3.
Remove the
battery
.
4.
Remove the
SIM card
.
5.
Remove the
SD card
.
6.
Remove the
ExpressCard
.
7.
Remove the
Smart card
.
8.
Remove the
hinge covers
.
9.
Remove the
access panel
.
10.
Remove the
optical drive
.
11.
Remove the
hard drive
.
12.
Remove the
LED cover
.
13.
Remove the
keyboard
.
14.
Remove the
coin-cell battery
.
15.
Remove the
memory
.
16.
Remove the
WWAN card
.
17.
Remove the
WLAN card
.
18.
Remove the
Latitude On™ Flash/CMG module
.
19.
Remove the
Fingerprint Reader
.
20.
Remove the
Heat Sink and Processor Fan
.
21.
Remove the
Display Assembly
.
22.
Peel back the Ferrite sheet covering the firewire cable.
23.
Disconnect and unthread the firewire data cable from the system board.
24.
Remove the screws that secure the IEEE 1394 board to the computer.
25.
Remove the IEEE 1394 board from the computer.
Replacing the IEEE 1394 Port
To replace the IEEE 1394 port, perform the above steps in reverse order.
Back to Removing and Replacing Parts
WARNING:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
NOTE:
You may need to install Adobe® Flash® Player from Adobe.com in order to view the illustrations below.