Palm rest, Removing the palm rest, Replacing the palm rest – Dell Latitude E6410 User Manual
Page 41
Back to Removing and Replacing Parts
Palm Rest
Dell™ Latitude™ E6410/E6410 ATG Service Manual
Removing the Palm Rest
1.
Follow the procedures in
Before Working Inside Your Computer
.
2.
Remove the
ATG Port Cover
(applicable on E6410 ATG computer only).
3.
Remove the
battery
.
4.
Remove the
SIM card
.
5.
Remove the
SD card
.
6.
Remove the
ExpressCard
.
7.
Remove the
Smart card
.
8.
Remove the
hinge covers
.
9.
Remove the
access panel
.
10.
Remove the
optical drive
.
11.
Remove the
hard drive
.
12.
Remove the
LED cover
.
13.
Remove the
keyboard
.
14.
Remove the
coin-cell battery
.
15.
Remove the
memory
.
16.
Remove the
WWAN card
.
17.
Remove the
WLAN card
.
18.
Remove the
Latitude ON™ Flash/CMG module
.
19.
Remove the
coin-cell battery
.
20.
Remove the
Fingerprint Reader
.
21.
Remove the
Heat Sink and Processor Fan
.
22.
Remove the
Display Assembly
.
23.
Remove the 8 screws (Number 1 is a captive screw) from the bottom of the computer.
24.
Remove the screws that secure the palm rest to the computer.
25.
Disconnect the speaker cable (1), power button cable (2), touch pad cable(3), and RFID cable (4).
26.
Lift the back edge of the palm rest and pull on the right side to release the right snaps. Once the right snaps release, pull the palm rest forward along
the front to release the front snaps and remove the palm rest.
Replacing the Palm Rest
To replace the palm rest, perform the above steps in reverse order.
Back to Removing and Replacing Parts
WARNING:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
NOTE:
You may need to install Adobe® Flash® Player from Adobe.com in order to view the illustrations below.
NOTE:
If the computer is installed with a standard palm rest, see the
fingerprint reader
removal instructions from step 8 to loosen the 9th screw
which is a captive screw.
NOTE:
RFID cable is available only if your computer is purchased with contactless smart card solution.