Dell Latitude E6410 - Manual (Page 28)

Back to Removing and Replacing Parts
Hard Drive
Dell™ Latitude™ E6410/E6410 ATG Service Manual
Removing the Hard Drive
1. Follow the procedures in Before Working Inside Your Computer .
2. Remove the ATG Port Cover (applicable on E6410 ATG computer only).
3. Remove the battery .
4. Remove the screws that secure the hard drive to the computer.
5. Slide and remove the hard drive out of the computer.
6. Remove the screw that secures the hard drive caddy to the hard drive.
7. Pull and remove the hard drive caddy away from the hard drive.
Replacing the Hard Drive
To replace the hard drive, perform the above steps in reverse order.
Back to Removing and Replacing Parts
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
NOTE: You may need to install Adobe® Flash® Player from Adobe.com in order to view the illustrations below.