Dell Latitude E6410 - Manual (Page 43)

Back to Removing and Replacing Parts
Processor
Dell™ Latitude™ E6410/E6410 ATG Service Manual
Removing the Processor
1. Follow the procedures in Before Working Inside Your Computer .
2. Remove the ATG Port Cover (applicable on E6410 ATG computer only).
3. Remove the battery .
4. Remove the access panel .
5. Remove the Heat Sink and Processor fan .
6. Rotate processor cam lock counter clock-wise.
7. Lift the processor and remove it from the computer.
Replacing the Processor
To replace the processor, perform the above steps in reverse order.
Back to Removing and Replacing Parts
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
NOTE: You may need to install Adobe® Flash® Player from Adobe.com in order to view the illustrations below.