Dell Latitude E6410 - Manual (Page 20)

Back to Removing and Replacing Parts
ExpressCard Cage
Dell™ Latitude™ E6410/E6410 ATG Service Manual
Removing the ExpressCard Cage
1. Follow the procedures in Before Working Inside Your Computer .
2. Remove the ATG Port Cover (applicable on E6410 ATG computer only).
3. Remove the battery .
4. Remove the Memory Card .
5. Remove the ExpressCard .
6. Remove the access panel .
7. Remove the hinge covers .
8. Remove the LED cover .
9. Remove the keyboard
10. Remove the hard drive .
11. Remove the fingerprint reader .
12. Remove the Heat Sink and Processor fan .
13. Remove the display assembly .
14. Remove the palm rest .
15. Remove the screws that secures the ExpressCard cage to the computer.
16. Lift the ExpressCard cage and slide the ExpressCard cage out of the computer.
Replacing the ExpressCard Cage
To replace the ExpressCard cage, perform the above steps in reverse order.
Back to Removing and Replacing Parts
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
NOTE: You may need to install Adobe® Flash® Player from Adobe.com in order to view the illustrations below.