Dell 1130 Laser Mono Printer - Manual (Page 15)

LED Status Description
Jam ( ) Orange On A paper jam has occurred. (See Clearing paper jams .)
Online/Error
(
)
Off The machine is off-line.
Green On The machine is in power saver mode.
The machine is on-line and can receive data from the computer.
Blinking When the LED blinks slowly, the machine is receiving data from the computer.
When the LED blinks rapidly , the machine is printing data.
Red On The cover is open. Close the cover.
There is no paper in the tray. Load paper in the tray.
The machine has stopped due to a major error.
Your system has some problems. If this problem occurs, contact your service
representative.
The toner cartridge has almost reached its estimated cartridge life
[ a ]
. It is
recommended to replace the toner cartridge. (See Replacing the toner cartridge .)
Blinking A minor error has occurred and the machine is waiting for the error to be cleared.
When the problem is cleared, the machine resumes.
Toner is low. Replace the cartridge. The estimated cartridge life
[ a ]
of toner is close.
Prepare a new cartridge for replacement. You may temporarily increase the printing
quality by redistributing the toner. (See Redistributing toner .)
[ a ] Estimated cartridge life means the expected or estimated toner cartridge life, which indicates the average capacity
of print-outs and is designed pursuant to ISO/IEC 19752. The number of pages may be affected by operating
environment, printing interval, media type, and media size. Some amount of toner may remain in the cartridge even
when red LED turned on and the printer stops printing.
Dell does not recommend using non-genuine Dell toner cartridge such as refilled or re-manufactured. Dell cannot
guarantee non-genuine Dell toner cartridge's quality. Service or repair required as a result of using non-genuine
Dell toner cartridges will not be covered under the machine warranty.
All printing errors will be appear in the Printer Status Monitor program window. If the problem persists, call for
service.
Buttons
(Cancel button)
By pressing the (cancel button), you can:
Function Description
Printing
demo
page
[ a ]
In Ready mode, press and hold this button for about 2 seconds until the status LED blinks slowly, and
release. (See Printing a demo page .)
Printing
configuration
sheet
[ b ]
In Ready mode, press and hold this button for about 5 seconds until the status LED blinks fast, and
release. (See Printing a machine report .)
Printing a
cleaning
sheet
[ b ]
In Ready mode, press and hold this button for about 10 seconds until the status LED blinks slowly, and
release. (See Cleaning the inside .)
Cancel print
job
Press (cancel button) during printing. The red LED blinks while the print job is cleared from both the
machine and the computer and then the machine returns to ready mode. This may take some time
depending on the size of the print job.
Manual print Press (cancel button) each time you load a sheet of paper in the
manual tray when you select Manual Feeder for Source from your software application.
[ a ] When you print the demo page for Dell 1130, configuration sheet is printed as well.
[ b ]
Dell 1130n only