Dell PowerVault DL2200 CommVault - Manual (Page 31)

About Your System
31
The amount of
system memory has
changed.
Memory has been added or
removed or a memory
module may be faulty. If memory has been added or
removed, this message is
informative and can be
ignored. If memory has not
been added or removed,
check the SEL to determine
if single-bit or multi-bit
errors were detected and
replace the faulty memory
module.
See "Troubleshooting
System Memory" on
page 137.
The following
DIMMs should
match in
geometry:
x , x , ...
Invalid memory
configuration. The specified
memory modules do not
match in size, number of
ranks, or number of
data lanes. Ensure that the memory
modules are installed in a
valid configuration.
See "General Memory
Module
Installation Guidelines" on
page 81.
The following
DIMMs should
match in rank
count: x , x , ...
The following
DIMMs should
match in size:
x , x , ...
The following
DIMMs should
match in size
and geometry:
x , x , ...
The following
DIMMs should
match in size
and rank count:
x , x , ...
Message Causes Corrective Actions
book.book Page 31 Wednesday, May 12, 2010 9:26 PM