Dell Inspiron 1526 (Late 2007) - Manual (Page 144)

142
Adding and Replacing Parts
Replacing the Keyboard
1 Slide the keyboard cable into the keyboard connector.
2 Rotate the keyboard connector latch to secure the cable.
3 Hook the tabs along the front edge of the keyboard into the palmrest.
4 Press on the right edge near the top to snap the keyboard into place.
5 Replace the two screws on the top of the keyboard.
Memory
CAUTION:
Before you begin any of the procedures in this section, follow the
safety instructions in the Product Information Guide.
You can increase your computer memory by installing memory modules on
the system board. See "Specifications" on page 161 for information on the
memory supported by your computer. Install only memory modules that are
intended for your computer.
NOTE:
Memory modules purchased from Dell are covered under your
computer warranty.
Your computer has two user-accessible SODIMM sockets, DIMM A and
DIMM B, accessed from the bottom of the computer.
NOTICE:
If you need to install memory modules in two connectors, install a
memory module in the connector labeled “DIMMA” before you install a module in
the connector labeled “DIMMB.”
Removing Memory Module
The memory modules are located under the memory module cover on the
bottom of the computer.
1 Follow the procedures in "Before You Begin" on page 133.
2 Turn the computer upside-down, loosen the eight captive screws on the
cover (see "Bottom View" on page 29), and remove the cover.