Dell XPS 720 (Mid 2007) - Manual (Page 106)

106
Removing and Installing Parts
If you installed an add-in network adapter and want to disable the integrated network adapter:
1 Enter system setup (see "Entering System Setup" on page 166), select Integrated NIC Controller, and
then change the setting to Off.
2 Connect the network cable to the add-in network adapter connectors. Do not connect the network
cable to the integrated connector on the back panel.
If you removed an add-in network connector:
1 Enter system setup (see "Entering System Setup" on page 166), select Integrated NIC Controller, and
then change the setting to On.
2 Connect the network cable to the integrated connector on the back panel of the computer.
Drives
Your computer supports:
• Six SATA devices (hard drives or optical drives)
• Two IDE devices (two hard drives or two optical drives)
• One floppy drive
• One Media Card Reader
NOTICE:
When removing and replacing drives, be sure to leave the drive data and power cables connected to the
system board.
NOTE:
The 5.25-inch Media Card Reader/floppy drive carrier is not interchangeable with the hard drive carrier.