Dell Studio XPS 9100 (Mid 2010) - Manual (Page 49)

Back to Contents Page
Front USB 3.0 Assembly
Dell™ Studio XPS™ 9100 Service Manual
Removing the Front USB 3.0 Assembly
Replacing the Front USB 3.0 Assembly
Removing the Front USB 3.0 Assembly
1. Follow the instructions in Before You Begin .
2. Remove the computer cover (see Removing the Computer Cover ).
3. Remove the front bezel (see Removing the Front Bezel ).
4. Disconnect the USB 3.0 cable from the connector on the expansion card.
5. Remove the two screws that secure the front USB 3.0 assembly to the chassis.
6. Push and slide the front USB 3.0 assembly out through the front of the computer.
7. Set the front USB 3.0 assembly aside in a secure location.
Replacing the Front USB 3.0 Assembly
1. Follow the instructions in Before You Begin .
2. Gently slide the front USB 3.0 assembly into the FlexBay slot through the front of the computer.
3. Replace the two screws that secure the front USB 3.0 assembly to the chassis.
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
WARNING: To guard against electrical shock, always unplug your computer from the electrical outlet before removing the cover.
WARNING: Do not operate your computer with any cover(s) (including computer covers, bezels, filler brackets, front-panel inserts, etc.)
removed.
CAUTION: Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
is not covered by your warranty.
1 USB 3.0 cable 2 front USB 3.0 assembly
3 screws (2)