CatEye CC-TR200DW (V2c) - Manual (Page 16)

ENG-31 ENG-30
ENG M2/- M1/+ M2/- M1/+
3. Pressing the MENU button returns to the menu top screen
(ODO InPUT screen), and confirm the change(s).
Pressing it again returns to the measurement screen.
To the menu top/measurement screen:
MENU
Setting the auto-mode
Switch on/off of the auto-mode (page 16).
1. Press the MENU button in the measurement screen to
switch to the menu top screen.
Switch to the AUTO MODE screen using the M1/+ and M2/-
buttons, and confirm with the SSE button.
Menu top:
MENU
Changing the menu: M1/+
M2/-
Confirm:
SSE
2. Select On or OFF using the M1/+ and M2/- buttons.
On ↔ OFF: M1/+
M2/-
3. Pressing the MENU button returns to the menu top screen
(AUTO MODE screen), and confirm the change(s).
Pressing it again returns to the measurement screen.
To the menu top/measurement screen:
MENU
Setting the countdown distance
Enter the target trip distance for the countdown (page 20).
1. Press the MENU button in the measurement screen to
switch to the menu top screen.
Switch to the C.D.DST
→ screen using the M1/+ and M2/-
buttons, and confirm with the SSE button.
Menu top:
MENU
Changing the menu: M1/+
M2/-
Confirm:
SSE
(or)
(or)
Current setting
Current setting
(or)
(Back)
(Back)
(Back)
(Back)
Setting the measurement unit
Change the unit (km or mile).
* Stop measurement and perform the resetting operation (page 16) before you change
the unit. Unless you perform the resetting operation, “DATA RESET” appears on
the screen, preventing from changing the unit.
1. Press the MENU button in the measurement screen to
switch to the menu top screen.
Switch to the UnIT screen using the M1/+ and M2/- buttons,
and confirm with the SSE button.
Menu top:
MENU
Changing the menu: M1/+
M2/-
Confirm:
SSE
2. Select the speed unit using the M1/+ and M2/- buttons.
km ↔ mile: M1/+
M2/-
3. Pressing the MENU button returns to the menu top screen
(UnIT screen), and confirm the change(s).
Pressing it again returns to the measurement screen.
To the menu top/measurement screen:
MENU
* After the unit is switched, the total distance measured in the past is automatically
converted to the new unit.
Total distance manual entry
You can enter any value to the total distance.
The total distance in the past can be input after formatting or to a new computer.
1. Press the MENU button in the measurement screen to
switch to the menu top screen.
Switch to the ODO InPUT screen using the M1/+ and M2/-
buttons, and confirm with the SSE button.
Menu top:
MENU
Changing the menu: M1/+
M2/-
Confirm:
SSE
2. Enter the total distance using the M1/+ and M2/- buttons,
and move digits using the SSE button.
* The total distance shall be entered with a positive value.
Increase/decrease: M1/+
M2/-
Move digits:
SSE
(or)
(or)
(or)
Current speed unit
Current total value
(Back)
(Back)
(Back)
(or)
Continue