Dell XPS One 2720 (Mid 2013) - Manual (Page 76)

76 | Replacing the Power-Button Assembly
Replacing the Power-Button Assembly
WARNING: Before working inside your computer, read the safety information
that shipped with your computer and follow the steps in "Before You Begin" on
page 11. After working inside your computer, follow the instructions in "After
Working Inside Your Computer" on page 13. For additional safety best practices
information, see the Regulatory Compliance Homepage at
dell.com/regulatory_compliance.
Procedure
1 Slide the power button into the slot on the display bezel and place the
power-button assembly on the display bezel.
2 Align the screw holes on the power-button assembly with the screws holes on
the display bezel.
3 Replace the screws that secure the power-button assembly to the display bezel.
4 Route the power-button cable through the routing guides and connect the
power-button cable to the system board.
Postrequisites
1 Replace the inner frame. See "Replacing the Inner Frame" on page 50.
2 Replace the system-board shield. See "Replacing the System-Board Shield" on
page 32.
3 Replace the stand. See "Replacing the Stand" on page 22.
4 Replace the trim cover. See "Replacing the Trim Cover" on page 20.
5 Replace the back cover. See "Replacing the Back Cover" on page 18.
6 Follow the instructions in "After Working Inside Your Computer" on page 13.
OM_Book.book Page 76 Wednesday, April 3, 2013 1:39 PM