Dell XPS One 2720 (Mid 2013) - Manual (Page 23)

Removing the Converter Board | 23
Removing the Converter Board
WARNING: Before working inside your computer, read the safety information
that shipped with your computer and follow the steps in "Before You Begin" on
page 11. After working inside your computer, follow the instructions in "After
Working Inside Your Computer" on page 13. For additional safety best practices
information, see the Regulatory Compliance Homepage at
dell.com/regulatory_compliance.
Prerequisites
Remove the back cover. See "Removing the Back Cover" on page 17.
Procedure
1 Lift the securing tab on the display-backlight cable connector and then disconnect
the display-backlight cable from the convertor board.
2 Disconnect the converter cable from the converter board.
3 Remove the screws that secure the converter board to the middle cover.
4 Lift the converter board off the middle cover.
1 screws (2) 2 converter cable
3 converter board 4 securing tab
5 display-backlight cable
5
2
3
1
4
OM_Book.book Page 23 Wednesday, April 3, 2013 1:39 PM