Before you add or replace parts, Adding memory – Dell Inspiron 300m User Manual
Page 102

102
Adding and Replacing Parts
www
.dell.com | support.dell.com
Before You Add or Replace Parts
CAUTION: Before working inside your computer, read the safety instructions on
1
Ensure that the work surface is flat and clean to prevent scratching the computer
cover.
2
Save and close any open files, exit any open programs, and then shut down the
computer (see "Turning Off Your Computer" on page 41).
3
Disconnect the computer from the electrical outlet.
4
Wait 10 to 20 seconds, and then disconnect any attached devices.
5
Remove any installed PC Cards and the battery.
NOTICE: Handle components and cards by their edges, and avoid touching pins and contacts.
Ground yourself by touching a metal connector on the back of the computer. Continue to ground
yourself periodically during this procedure.
Adding Memory
You can increase your computer memory by installing a memory module on the system
board. See "Memory" on page 116 for information on the memory supported by your
computer. Be sure to add only a memory module that is intended for your computer.
CAUTION: Before working inside your computer, read the safety instructions on
NOTE: Memory modules purchased from Dell are covered under your computer warranty.
1
Ensure that the work surface is flat and clean to prevent scratching the
computer cover.
2
Save and close any open files, exit any open programs, and shut down the computer
(see "Turning Off Your Computer" on page 41).
3
If the computer is connected to the media base (docked), undock it. See the
documentation that came with your media base for instructions.
4
Disconnect the computer from the electrical outlet.
5
Wait 10 to 20 seconds, and then disconnect any attached devices.